On this island, we often get power outages, flickers or blips that may cause a UV power supply to come back on beeping, or the lamp won't power up properly and be alarming. With many of the newer models of UV this won't be an issue, but with some of the older systems, or just with the idiosyncracies of the Hydro feed to your house, you may need to deal with this each time.
If beeping or UV lamp out after power is restored, try the following steps:
If beeping or UV lamp out after power is restored, try the following steps:
- Unplug UV at outlet and wait 10 long seconds.
- Then, while pressing down reset button of UV power supply (if it has one), plug UV back in and wait for the following (depending on UV power supply model): solid beep and then it silences, or solid beep and the words on LED display "reSET". As soon as this occurs, take finger off reset button.
- The beeping should stop and lamp should light up. If it does not, it may be that the power supply has been damaged from the outage, or more rarely, the UV lamp is burnt out.
- Contact your service technician to confirm problem.
To protect your UV power supply and lamp function, it is always advised that no other fairly heavy power-using appliances (e.g. jet pump or centra-vac) be on the same plug or circuit, and that the outlet be GFCI and also have a plug-in style surge protector on it too.
If any past reasons or suspicions of unsafe water, you will need to sanitize with chlorine and/or thoroughly flush your water lines after power is restored and your UV is confirmed operational.
No comments:
Post a Comment